Separated Solid Fill settings into an individual tab.Ģ7. Added an option to print Infill with Lines Pattern when Infill Pattern is set as Grid and the Infill Ratio is over 25%.Ģ4. Added an option to print Infill as Solid Fill and use Settings for Solid Fill when the density of the Infill is set to 100%.Ģ2. Added an option to connect the endpoints of Infill Lines for Grid, Triangles, and Cubic type Infill.Ģ1. Added an option to fill the gaps among Infill Outline Shells.Ģ0. Added an option to fill the gaps when 100% Concentric Infill is selected.ġ9. Added more conditions for enabling Z hop.ġ8. Small Features Diameter = 8mm, Speed Multiplier = 50%, Small Features Infill Density = 100%ġ6. When the diameter of a selected area is lower than the set value, or when the diameter of holes on shells is lower than the set value, these sections will be printed out with the settings of Small Features, which requires lower printing speeds and increases infill density. Added Wipe Tower Minimal Volume to control the minimal extrusion amount of how many loops for each nozzle when WipeTower Type has been selected as Nested.ġ5. Added more types of WipeTower: Interlaced, Nested, and Multiple.ġ4. Added more types of WipeWall: Interlaced and Nested.ġ2. Added options to print Support Infill or Dense Support Infill with Lines Pattern when Support or Dense Support Infill Pattern is set as Grid and the Support or Dense Support Infill Ratio is over 25%.ġ1. Separate settings for Top and Bottom Dense Support Layers.ġ0. Once Support Horizontal Expansion has been enabled, support structures will be added to the expanded support structures.ĩ. More dense support structures will be added to the existing support structures.Ĩ. Added Dense Support Inner Horizontal Expansion. When this option has been enabled, the retraction will only happen before the nozzle travels across the model.ħ. Added the option to disable unnecessary retractions when printing supports. Support will be generated around the scaled and rotated Manual Support Pillars.Ĥ. Added Rectilinear, Triangles, and Gyroid for Support Fill Type, and Rectilinear for Dense Support Fill. Note: When the Dense Support Layer feature is enabled, the maximum value of this range will be the same as the Dense Support Infill Ratio.Ģ. You can also adjust the range for the Support Infill Ratio. This can help save printing time and minimize support material. Or, the further apart they are, the lower the Infill Ratio can be set. The closer the support structures are to the model, the higher the Infill Ratio can be set. The Infill Ratio for the Support Structure can now be adaptively set. New requested features and debugging based on user feedback.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |